[syslinux] PXELINUX fall to exit PXE ROM
xbgmsharp
xbgmsharp at gmail.com
Fri Jul 16 01:27:54 PDT 2010
Hello,
i compile from source after comment out the call to
install_efi_csm_hack() in reset_pxe() in the file core/fs/pxe/pxe.c
The result is that i can see after "Booting from local disk..." this message:
"PXE-M0F: Exiting Broadcom PXE ROM" but it still loop on the same
network interface.
Francois
>>
>> x3550M2
>> The Bios is a UEFI one, i have test with the latest version and older
>> one as well. The system boot only on Legacy support.
>> NIC: Broadcom Corporation NetXtreme II BCM5709 Gigabit Ethernet
>> PXE: Broadcom UNDI PXE 2.1 V5.2.7
>>
>> x3550M3
>> The Bios is a UEFI one, i have test with the latest version and older
>> one as well. The system boot only on Legacy support.
>> NIC: Broadcom Corporation NetXtreme II BCM5709 Gigabit Ethernet
>> PXE: Broadcom UNDI PXE 2.1 V5.2.2
>>
>
> Do you have the ability to compile Syslinux from scratch? If so, could
> you comment out the call to install_efi_csm_hack() in reset_pxe() in the
> file core/fs/pxe/pxe.c?
>
>
> -hpa
More information about the Syslinux
mailing list