[syslinux] Serial with syslinux
n schembr
nschembr at yahoo.com
Thu Nov 9 14:42:32 PST 2006
The Startech.com pci2s550 can not be remapped to ports 1-4 before the system boots. The company is not supporting linux serial ports as consoles 0-3 , thank you starTech.com.
----- Original Message ----
From: n schembr <nschembr at yahoo.com>
To: SYSLINUX at zytor.com
Sent: Thursday, November 9, 2006 4:58:50 PM
Subject: [syslinux] Serial with syslinux.
Can syslinux be upgraded to support more then 4 serial ports?
Could syslinux be configured to auto probe for the first serial port?
Ubuntu 6.6.1 boots and can find the card at port ttyS4 and ttyS5.
Voyage (debian) linux reset the pci serial card and assigns it to ttyS0 and ttyS1
A few weeks back I asked about a boot loader with ttyUSB support. It was pointed out that a USBserial stack would be very bloated. So I purchased a pci serial IO card.
ON boot up the card is configured to port 4 to avoid conflicts with the on board hardware.
Ubuntu 6.6.1 boots and can find the card at port ttyS4 and ttyS5.
Voyage linux (debian) reset the pci serial card and assigns it to ttyS0 and ttyS1
syslinux and extlinux can not see the card at boot up. Can extlinux be configured to auto probe and use the first serial port it finds?
serial -1 115200
Thank you for your hard work,
Nicholas A. Schembri
State College PA USA
_______________________________________________
SYSLINUX mailing list
Submissions to SYSLINUX at zytor.com
Unsubscribe or set options at:
http://www.zytor.com/mailman/listinfo/syslinux
Please do not send private replies to mailing list traffic.
More information about the Syslinux
mailing list