[syslinux] Syslinux 3.70pre9 - sanboot.c32 says: gPXE API not detected'

[Nico de Haer]

Peter,

I downloaded/installed pre10 and I'm happy to report that my 2nd attempt
resulted in a booting windows xp! I had to make one minor change in my
configuration. It now reads:

 LABEL  doaoe
     MENU LABEL Continue AoE
     sanboot.c32 aoe:e0.0

Regards,
Nico


On Wed, May 28, 2008 at 6:50 PM, H. Peter Anvin <hpa at zytor.com> wrote:

> Nico de Haer wrote:
> > Hi,
> >
> > I have a working PXE environment that chainloads gPXE and loads
> pxelinux.0
> > afterwards. As I'm also interested in doing san boot (in my case aoe) I
> > tried loading the new gpxelinux.0 file instead of my gPXE --> pxelinux.0
> > setup (works) and booting from my aoe target by adding this to the
> default
> > config file:
> >
> > LABEL  doaoe
> >     MENU LABEL Continue AoE
> >     kernel sanboot.c32
> >     append aoe:e0.0
> >
> > The result is that sanboot.c32 is complaining that the gPXE API is not
> > detected. Please note that I can boot my machine from the aoe target
> using
> > the gPXE command-line
> >
> > I have also tried adding the keeppxe keyword at the end of the append
> line
> > but this has the same result.
> >
> > Any ideas why this is not working?
> >
>
> Hi Nico,
>
> Thank you for the bug report.  I just tracked down this problem, and am
> pushing syslinux-3.70-pre10 right now.  If you could please test it out
> I would be most grateful!
>
>        -hpa
>
> _______________________________________________
> SYSLINUX mailing list
> Submissions to SYSLINUX at zytor.com
> Unsubscribe or set options at:
> http://www.zytor.com/mailman/listinfo/syslinux
> Please do not send private replies to mailing list traffic.
>
>