[syslinux] PXELinux cannot load the config file
Lunde, Steven M
steven.m.lunde at boeing.com
Wed Oct 29 11:32:38 PST 2003
You were correct. The server address was 0.0.0.0. I added the BootSrvA option to my Solaris DHCP server and this fixed the problem.
Thank you.
Steve
-----Original Message-----
From: H. Peter Anvin [mailto:hpa at zytor.com]
Sent: Wednesday, October 29, 2003 9:48 AM
To: Lunde, Steven M
Cc: syslinux at zytor.com
Subject: Re: [syslinux] PXELinux cannot load the config file
Lunde, Steven M wrote:
>
> The abbreviated form of ethernet packets follows to provide the big
> picture. Suspect frames are 29 and 30, detailed packets for these
> frames are provided below this output. Is there any significance with
> the fact that the first tftp request is directed from the client->server
> (Frame 7) while the one that fails is client->broadcast (Frame 29)?
>
Yes, it does. Please give *all* messages printed out by PXELINUX during
the boot... most likely it will have a server address of 0.0.0.0, but it
could also be a PXE stack bug. If the server address is all zero, it
would be very helpful to have a complete capture of the DHCP packets.
-hpa
More information about the Syslinux
mailing list