[syslinux] Memdisk problem when no hard drives are in system
Mike Nolterieke
mikenol at us.ibm.com
Mon May 9 06:13:59 PDT 2005
Hi,
I am having a problem where an 8MB DOS PXE image that I use with memdisk
to update the firmware of my systems does not boot when there are no (or
failed) hard drives in the system. This process normally works fine but I
get this error message "=Nf000f859 Failure, assuming this is the only
drive" followed by "Non-System disk or disk-error" when the hard drives are
missing or have failed.
Any ideas on what is going on?
Mike
More information about the Syslinux
mailing list